![Easier Segmented Bowl Design](images/boaldesigneasy.gif) |
Now here are the steps:
- Draw the outer walls of the bowl.
- Draw the inner walls if you need them; they're
not required. You do need, however, to decide how thick the walls should
be; .5" in our case.
- Draw horizontal lines to mark the layer
boundaries, in this case .75" spacing.
- Measure off the diameter of the bowl at each
layer boundary, including the bottom, 3, 4.33, 4.9, etc.
- Transfer these measurements into the Segmented
Project Planner.
-
Exercise the AutoBowl function with the wall thickness set to .5.
|